•
If the parameter has an edit-copy, the original parameter value is
restored.
•
If the parameter does not have an edit-copy, the edited parameter
value remains visible until you reboot the IED. However, the
edited value is not stored in non-volatile memory and the reboot
restores the original value.
•
To cancel saving settings, select
Cancel
and press
.
After certain parameters are changed, the IED has to be restarted.
4.1.14
Clearing and acknowledging
The Clear button is used to reset, acknowledge or clear all messages and
indications, including LEDs and latched outputs as well as registers and recordings.
Press the Clear button to activate a selection menu, and select the wanted clearance
or reset function. Events and alarms assigned to programmable LEDs are cleared
with the Clear button as well.
1.
Press
to activate the Clear view.
A070860 V3 EN
Figure 25:
Clear view
2.
Select the item to be cleared with
or
.
3.
Press
, change the value with
or
and press
again.
The item is now cleared.
4.
Repeat steps 2 and 3 to clear other items.
Use the
button as a shortcut for clearing. The first three-second
press clears the indications. The second three-second press clears
the programmable LEDs.
1MRS756708 C
Section 4
Using the HMI
615 series
43
Operation Manual