2TLC172094M0201, rev. B
8
www.abb.com/lowvoltage
2012-08-03
5
Operation
Smile 11EA AS-i
Emergency stop:
Push the emergency stop button. An actuating force of 22 ± 4 N is required and the actuator travel is approximately
4 mm to latch.
Unlatch emergency stop button:
Turn the button clockwise until the button is unlatched.
Smile 11SA AS-i
Safety stop:
Push the safety stop button. An actuating force of 22 ± 4 N is required and the actuator travel is approximately 4
mm to latch.
Unlatch safety stop button:
Turn the button clockwise until the button is unlatched.
LED indication
The LED indication is identical on both models (Smile 11EA AS-i and Smile 11SA AS-i).
LED in pushbutton:
The LED indication is programmed individually in the PLC-program according to the table below.
LED
Indication
Description
Red
ON
Out bit 1 ON
OFF
Out bit 1 OFF or Out bit 1&2 ON.
Green
ON
Out bit 2 ON
OFF
Out bit 2 OFF or Out bit 1&2 ON.
AS-i LED and Fault LED in combination:
LED pair by the M12-connector.
AS-i (Green)
Fault (Red)
Description
OFF
OFF
AS-i power missing
ON
OFF
Normal operation
ON
ON
No data exchange with master
Flash
ON
No data exchange because address = 0
