ABB IRC5 with FlexPendant, Руководство по эксплуатации

Страница: 151 / 306

Loading an existing program
This section describes how to load an existing program.
Action
On the ABB menu, tap Program Editor . 1
Tap Tasks and Programs . 2
Tap File , then Load Program . 3
If there was already a program loaded, a warning dialog appears.
• Tap Save to save the loaded program.
• Tap Don't save to close loaded program without saving it, i.e. delete from pro-
gram memory.
• Tap Cancel to leave the loaded program.
Use the file searching tool to locate the program file to be loaded (file type pgf). Then
tap
OK .
The program is loaded and the program code is displayed.
en0400000699
4
Saving a program
This section describes how to save a loaded program to the controller’s hard disk.
A loaded program is automatically saved in the program memory, but saving to
the controller hard disk is an extra precaution.
Action
On the ABB menu, tap Program Editor . 1
Tap Tasks and Programs . 2
Tap File and select Save Program As... . 3
Use the suggested program name or tap ... to open the soft keyboard and enter a new
name. Then tap OK .
4
Continues on next page
Operating manual - IRC5 with FlexPendant 151
3HAC050941-001 Revision: G
© Copyright 2018 ABB. All rights reserved.
5 Programming and testing
5.3.1 Handling of programs
Continued