ABB IRC5 with FlexPendant, Руководство по эксплуатации

Страница: 105 / 306

3.7.1.6 Defining position programming rule
Introduction to position naming
Robot positions in a RAPID program are either named variables or not named
(using the asterisk character, *). The programmer can choose which naming rule
the FlexPendant should use when new move instructions are programmed.
Defining position programming rule
Use this procedure to define a naming rule for new robot positions.
Action
On the ABB menu, tap Control Panel and then FlexPendant . 1
Tap Position Programming Rule .
en0500002415
2
Tap to select the preferred position programming rule. 3
Tap OK . 4
Position programming rules
This section gives a detailed description of the options available when programming
robot positions, here referred to as
targets . This signifies the position to which the
mechanical unit is programmed to move.
New targets can be named according to any of these principles:
• New position created; * or sequential naming rule.
• Next sequential already existing position selected.
• No new position created; * naming rule.
New position created; * or sequential naming rule
This is the default setting. When a move instruction is programmed, a new target
will automatically be created. If the last target was named, that is
not using an “*”,
the new target will be named in sequence with the previous one.
Continues on next page
Operating manual - IRC5 with FlexPendant 105
3HAC050941-001 Revision: G
© Copyright 2018 ABB. All rights reserved.
3 Navigating and handling FlexPendant
3.7.1.6 Defining position programming rule