ABB IRB 6650S Series, Руководство по эксплуатации продукта

Страница: 369 / 450

Required equipment
Note Art. no. Equipment
Includes
• gearbox
• o-ring.
Does not include "Sealing, axis 2/3"!
For spare part number,
see
Spare part lists on
page 425 .
Gearbox axis 2
O-ring in gearbox, 1 pc. 3HAB3772-77 O-ring
O-ring in the cover, axis 2, 1 pc.
Should be replaced if damaged! 3HAB3772-73 O-ring
A new sealing must be used on
each assembly! 3HAC020123-001 Sealing, axis 2
For lubricating o-rings. 3HAB3537-1 Grease
3HAC020729-001 Fixture lower arm
3HAC020386-001 Lifting tool, gearbox axis 2
For guiding the gearbox. 3HAC13056-2 Guide pins M12 x 150
For guiding the gearbox. 3HAC13056-3 Guide pins M12 x 200
3HAC020902-001 Press tool, balancing device
To be used with the press tool and
the hydraulic pump, when unloading
the balancing device. 3HAC11731-1 Hydraulic cylinder
To be used with the press tool and
the hydraulic cylinder, when unload-
ing the balancing device. 3HAC13086-1 Hydraulic pump, 80 MPa
For guiding the sealing! 3HAC14628-1 Guide pins, sealing ax 2/3,
80mm
For guiding the sealing! 3HAC14628-2 Guide pins, sealing ax 2/3,
100mm
Used to turn the gear in correct po-
sition. 3HAC020999-001 Gearbox crank, axis 2
The contents are defined in section
Standard tools on page 435 in part 2
of the Product manual.
- Standard toolkit
These procedures include refer-
ences to the tools required. Other tools and procedures
may be required. See refer-
ences to these procedures
in the step-by-step instruc-
tions below.
Continues on next page
Product manual - IRB 6650S 369
3HAC020993-001 Revision: Z
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.7.2 Replacement of gearbox axis 2
Continued