ABB IRB 4600 - 20/2.50, Руководство по эксплуатации продукта

Страница: 319 / 374

5 Calibration
5.1 Introduction
General
This chapter includes general information about the different calibration methods
and also the detailed procedures that do not require specific calibration equipment.
When the robot system must be recalibrated, it is done according to the
documentation enclosed with the calibration tools.
When to calibrate
The system must be calibrated if any of the following situations occur.
The resolver values are changed
If resolver values are changed, the robot must be recalibrated using the calibration
methods supplied by ABB. Calibrate the robot carefully with standard calibration.
The different methods are briefly described in the section
Calibration methods on
page 320 , and further detailed in separate calibration manuals.
If the robot has absolute accuracy calibration, it is also recommended, but not
always necessary to calibrate for new absolute accuracy.
The resolver values will change when parts affecting the calibration position are
replaced on the robot, for example motors or parts of the transmission.
The revolution counter memory is lost
If the revolution counter memory is lost, the counters must be updated. See
Updating revolution counters on page 326 . This will occur when:
• The battery is discharged
• A resolver error occurs
• The signal between a resolver and measurement board is interrupted
• A robot axis is moved with the control system disconnected
The revolution counters must also be updated after the robot and controller are
connected at the first installation.
The robot is rebuilt
If the robot is rebuilt, for example, after a crash or when the reach ability of a robot
is changed, it needs to be recalibrated for new resolver values.
If the robot has absolute accuracy calibration, it needs to be calibrated for new
absolute accuracy.
3HAC033453-001 Revision: H 319
© Copyright 2009-2013 ABB. All rights reserved.
5 Calibration
5.1 Introduction