ABB IRB 390, Руководство по эксплуатации продукта

Страница: 46 / 346

3.2 Unpacking
3.2.1 Pre-installation procedure
Introduction
This section is intended for use when unpacking and installing the robot for the
first time. It also contains information useful during later re-installation of the robot.
Prerequisites for installation personnel
Installation personnel working with an ABB product must:
• Be trained by ABB and have the required knowledge of mechanical and
electrical installation/maintenance/repair work.
• conform to all national and local codes.
Checking the pre-requisites for installation
Action
Make a visual inspection of the packaging and make sure that nothing is damaged. 1
Remove the packaging. 2
Check for any visible transport damage.
Note
Stop unpacking and contact ABB if transport damages are found.
3
Clean the unit with a lint-free cloth, if necessary. 4
Make sure that the lifting accessory used (if required) is suitable to handle the weight
of the robot as specified in:
Weight, robot on page 37
5
If the robot is not installed directly, it must be stored as described in: Storage condi-
tions, robot on page 38
6
Make sure that the expected operating environment of the robot conforms to the
specifications as described in:
Operating conditions, robot on page 39
7
Before taking the robot to its installation site, make sure that the site conforms to:
• Loads on foundation, robot on page 37
• Protection classes, robot on page 39
• Requirements, foundation on page 38
8
When these prerequisites are met, the robot can be taken to its installation site as
described in section:
On-site installation on page 47
9
Install required equipment, if any.
• Signal lamp (option) on page 72
10
46 Product manual - IRB 390
3HAC066566-001 Revision: B
© Copyright 2020 - 2021 ABB. All rights reserved.
3 Installation and commissioning
3.2.1 Pre-installation procedure