ABB HVC 150P, Руководство пользователя, Страница: 18 / 25

Document: v0.4 / Document No.: 6AGA000008-0607-EN | Date: 22-05-2019 Page 18 of 25
5. Operator Instructions
5.1. Cleaning of the cabinet and charge pole
DANGER
Electrical components
•
Do not apply high-pressure water jets. Water may leak into the
cabinet.
•
Only use cleaning agents with a pH value between 6 and 8.
•
Do not use cleaning agents with abrasive components.
•
Do not use abrasive tools.
The cabinet of the Power Cabinet and Charge pole is made from powder coated high quality
stainless steel. The coating must be kept in good condition.
Clean the Charger three times a year in the following way:
•
Remove rough dirt by rinsing with low-pressure tap water.
•
Apply a neutral or weak alkaline cleaning solution and let it soak.
•
Remove dirt by hand with a non-woven nylon hand pad.
•
Rinse thoroughly with tap water.
•
Optionally, apply wax on the front for extra protection and gloss.
•
Check the coating on damage.
NOTICE
Rust forming
When the charger is placed in a corrosion sensitive environment, the
forming of superficial rust is possible on the welding points on the side
grills. This rust is merely visual, there is no possibility this will form a risk
on the cabinets integrity.
The rust can be removed with the cleaning procedure above. To prevent
the rust from reappearing; prime the areas with a transparent or color-
like priming finish.
5.2. Preventive maintenance
Maintenance is done according the maintenance schedule. The charger must be inspected
and serviced yearly by a certified technician.
5.2.1. Service inspection of the cabinets
The following points must be checked regularly:
•
Internal RCDs and RCBOs need to be tested on correct functioning on a regular basis.
During the yearly maintenance round that is advised to be executed by a certified ABB
technician, this will be checked.
•
Powder coating: look for damage, cracks or ruptures.