ABB FSO-21, Руководство пользователя

Страница: 353 / 540

Configuration 353

How to configure SSE with immediate STO, SBC after or before STO
The configuration is identical to the SBC after or before STO functions with these
differences:
• parameter STO.13 Restart delay after STO is not used
• SSE input parameters ( SSE.11 SSE input A and SSE.12 SSE input B ) are used
instead of STO input parameters
• SSE output parameters ( SSE.21 SSE output and SSE.22 SSE completed output )
are used instead of STO output parameters.
See sections How to configure SBC after STO on page 333 and How to configure
SBC before STO on page 335 .
For more information on the SSE with immediate STO and SBC after STO function,
see page
109 .
For more information on the SSE with immediate STO and SBC before STO function,
see page
112 .

How to configure SSE with immediate STO with speed limit
activated SBC
This safety function requires that an encoder is used. Configure the safety encoder
interface first (see section
Configuring the safety encoder interface on page 313 ).
The configuration is identical to the STO with speed limit activated SBC function with
these differences:
• parameter STO.13 Restart delay after STO is not used
• SSE input parameters ( SSE.11 SSE input A and SSE.12 SSE input B ) are used
instead of STO input parameters
• SSE output parameters ( SSE.21 SSE output and SSE.22 SSE completed output )
are used instead of STO output parameters.
Note : If you configure the SSE with immediate STO with speed limit activated SBC
function, this activates the same function in the STO function (see section How to
configure STO with speed limit activated SBC on page 337 ).
For more information on the SSE with immediate STO with speed limit activated SBC
function, see page
115 .