ABB FlexLoader, Руководство по применению

Страница: 29 / 68

4 Maintenance
Maintenance schedule
This sections covers both maintenance of equipment and options that are not
included in all cells. If the installation contains further parts, maintenance instruction
may also be found in other documentation.
Below is a summary of the maintenance intervals and the corresponding corrective
actions.
Corrective action Maintenance intervals
Check for dirt. Every week
Check the safety functions. Every month
Check the safety sensors and actuators
Check the cables and cable racks. Every 3 months
Maintenance intervals
DANGER
Service of safety devices may only be performed by authorized personnel.
Check the safety functions
What: Test all safety functions.
When: Every month.
How: Go through all safety functions, that is all emergency stop buttons, all door
switches, and any other safety devices.
Other safety devices can include e.g. light guards, external machine actuators,
pneumatic safety valves, SafeMove restrictions, and laser scanners.
Check the safety sensors and actuators
What: Check the safety sensors and actuators
When: Every month.
How: In the event of wear or damage, the breaker, key switch, magnetic lock or
other safety-related parts must be replaced in its entirety.
Check for dirt
What: Check for dirt.
When: Every week.
How: Breakers, key switch, magnetic lock and other safety-related parts must be
clean. Remove any dirt.
Check the cables and cable racks
What: Check the cables and cable racks
When: Every 3 months.
How: Inspect the entire cable rack (installation points, dirt deposits, wear) and
remedy any breaks. Check all cables. Replace damaged cables. Extend cables
that rub against sharp edges.
Application manual - FlexLoader Standard Safety Center 29
3HAC051769-001 Revision: E
© Copyright 2014-2020 ABB. All rights reserved.
4 Maintenance