1
2
4
5
3
6
Open
Open
Ferrule
Stripped
Wire
FER9500 SQUARE CRIMP & FER9501 HEX CRIMP
COMFORT CRIMP
®
COMPRESSION TOOL WITH SHURE STAKE
®
MECHANISM
For Installing Ferrules 26-8 AWG & 0.14-10mm
2
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
In the event the SHURE STAKE
®
mechanism must be released, please see Figure 3.
TA05264
B
Page 1 of 2
Ferrule and Crimp Installation
1.1
1.0
INSTRUCTIONS FOR USE
1. Open handles fully.
2. Position ferrule into the tool.
3. Close handles slightly
to secure ferrule. Do not
deform ferrule.
4. Insert stripped wire into the
ferrule.
5. Close handles until the
SHURE STAKE
®
mechanism
cycle has been completed.
6. Open tool and remove
crimped ferrule and wire.
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
Figure 1
Figure 2
WARNING
DO NOT CRIMP ON HOT
ENERGIZED WIRES. DISCONNECT
POWER BEFORE INSTALLATION.
