ABB D1M 20, Руководство пользователя

Страница: 18 / 68

18
D1M 20
POWER METER USER MANUAL
x4
x8
x1
1. Press “ Up ” to increase the numerical characters from 0 to 9, until the required character is obtained.
• How to Go back to a previous number
If during the data entry the desired number is exceeded by mistake, it is needed to increase the displayed
number until data entry starts again from 0.
• Add a second digit
5.3.Data entry
Some of the pages require the entry of numerical characters (0-9) in the Configuration mode. In these
cases, the display will show an active field identified by a flashing number.
Data entry procedure
Press the “ OK ” button to start setting on the specified parameter page, and the parameter starts to blink
display.
The data entry procedure is as follows:
• Short press the “
Up
” Arrow button to set the first(on the far left) numerical character in a loop from “0”
to “9” and “0.0”, until the required character is obtained.
• Short press the “ Down ” Arrow button to confirm the first numerical character and move this character
to the left, or confirm the first decimal point.
• Repeat the step 1 and 2 to set the second and other numerical characters, it’s the same method as the
first numerical character.
• It will add a character “0” on the right side when short press the “ Down ” Arrow button to move current
numerical characters to the left.
The following will be combined with the display to describe how to complete the data entry.