ABB CRB 15000, Руководство по эксплуатации продукта, Страница: 217 / 1096

Note Action
Hex socket head cap screw: M3x8
12.9 Lafre 2C2B/FC6.9 (8 pcs) Refit the bottom cover with the attachment screws.
Note
For CRB 15000-5/0.95, fit the cover in correct dir-
ection, the protrusion of the cover must face out-
wards.
2
Tightening torque: 1.4 Nm.
xx2300000760
Lifting and securing the robot (-5/0.95)
Note Action
CAUTION
The CRB 15000 robot weighs 28 kg. A minim-
um of two persons are required for lifting as
well as securing the robot in order to avoid any
damage, instability, and injury.
1
Special consideration is necessary when
mounting the robot in an elevated, suspended
or wall mounted position.
xx2100000118
Grasp the robot at the foot and elbow, as
shown in the figure, and lift it up from the
transportation package. 2
Carry the robot to the installation site.
CAUTION
Do not leave the robot standing unfastened to
the foundation, it is not stable on its own.
3
Centering pins: DIN6325, hardened
steel Ø6x24 mm, 2 pcs . Fit two pins to the holes in the base. 4
Screws: M10x35, 4 pcs, quality 8.8 Raise the robot to standing and secure to
foundation, paying attention to the centering
holes at the bottom of the robot base.
• Person 1: keep holding the robot stable.
• Person 2: secure the robot base to the
foundation with the securing screws and
washers.
5
Washers: 23/10.5/2.5 mm Steel
Tightening torque: 32 Nm ±10% Tighten the bolts in a crosswise pattern to en-
sure that the base is not distorted. 6
Continues on next page
Product manual - CRB 15000 217
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the base cabling
Continued