ABB CP435, Инструкция по установке и эксплуатации

Страница: 18 / 29

Operation
18 ABB, 1SBC159108M0201
6.2 System Menu
Set the dip switch SW7 = ON . After the self-test, the system menu of the oper-
ator terminal is displayed on the screen:
The functions of the commands are briefly explained below:
System menu
command
Function
Link The operator terminal is connected.
F2 - Confg Sets up the internal time clock and communication parameters
in the operator terminal. All the settings has to be made for
the operator terminal to work properly.
Use , , and to move to desired field; + and - to set
the value of the field.
F3 - Copy Copies application data to another CP435.
F4 - Set Calibrates the touch panel and clears data RAM.
See also section
6.6 Touch Screen Calibration .
F5 - Run Runs the application.