ABB COM600 4.0, Руководство по эксплуатации

Страница: 14 / 34

To change the node load:
1.
In COM600 HMI, select FDIR.
The FDIR Control dialog opens.
2. In the FDIR Control dialog, select the FDIR Simulation tab.
3. In the Switch ID list, select the switch name.
4. In the Measurements field, type a new load value.
5. Click Set Measurement.
Changing source capacity limit 3.4.
To change source capacity limit:
1.
In COM600 HMI, select FDIR.
The FDIR Control dialog opens.
2. In the FDIR Control dialog, select the Source Capacity tab.
FDIR_Simulate_Fault
Figure 3.4-1 Fault simulation
3. In the Source ID list, select the source name.
14
1MRS757279
Grid Automation Controller COM600 4.0
FDIR Operation Manual