ABB CEMcaptain GAA610-M, Инструкция по эксплуатации

Страница: 81 / 100

GAA610-M
ADVANCED EMISSION GAS MONITORING SYSTEM | OI/GAA610-M-EN REV. B 81
Soot filter
A
Sample gas inlet from SCC-C
B
Sample gas outlet to SCC-F
1
Coupling nut
2
Filter element
3
Filter housing
4
Raschig rings
5
Condensate drain
Figure 46: Soot filter
The oil/soot removal filter is located behind the front door of the
analyzer cabinet.
Changing of the filter filling and the filter element
1. Activate the ‘Maintenance Mode’ on the control panel.
2. Turn off main switch.
3. Remove the hose from the sample gas inlet.
4. Open the condensate drain and dispose of escaping medium
in an environmentally friendly manner.
5. Close and seal the condensate drain.
6. Unscrew the filter housing.
7. Dispose of the soiled raschig rings in an environmentally
friendly manner.
8. Unscrew the soiled filter element from the filter housing and
dispose of it in an environmentally friendly manner.
9. Screw the new filter element into the filter housing and seal
the upper opening.
1
Raschig rings
2
Seal
3
Filter element
4
Filter housing
Figure 47: Replace filter element
10. Fill the new raschig rings into the filter housing.
11. Screw the filter housing in the coupling nut.
12. Connect the hose to the sample gas inlet.
13. Turn on main switch.
14. Check the seal integrity according to the description in .
15. Deactivate the ‘Maintenance Mode’ on the control panel.