8 OI/ATS430–EN Rev. H
| Aztec ATS430 | Turbidity sensor
5 Sensor setup
1.
Connect the ATS430 sensor to the transmitter’s EZLink
connector – see transmitter Operating instruction
OI/AWT440-EN.
2. At the AWT440 transmitter, press the
key to display the
Operator Page
menu,
then
select
Enter Configuration
to
display the
Access Level
page.
Use the
key to select the
Advanced
menu item and
press the
key (below the
Select
prompt).
If the
Sensor Setup
menu is not displayed use the
/
keys to scroll to it:
Press the
key (below the
Select
prompt).
3. The
Sensor Setup
page is displayed:
Ensure
Sx :Turb TSS
is highlighted and press the
key
(below the
Select
prompt).
The
Sx :Turb TSS
:
Turbidity
menu page is displayed:
4. Proceed with sensor setup – see Section 6.1, page 10
for parameter options.
IMPORTANT (NOTE)
Perform this procedure on existing sensor(s) only.
Sensors are setup / configured individually. If installing a
new / replacement sensor, refer to Section 4, page 7.
Exit
Select
Menu
Sensor Setup
1
2
3
Sensor Setup
Sx: Turb TSS
Back
Select
1
2
3
Sx :TURB TSS
Tag
PV Type
Units
Range High
Range Low
Clean Interval
Back
Select
