ABB ADC-90-200-C1, Руководство по эксплуатации и установке, Страница: 69 / 117

Procedure
1. De-energize the EVSE. Refer to section
6.6 .
2. Open the left and right doors. Refer to
section 8.1 .
3. Loosen the nuts (A).
Use the spanner.
4. Carefully remove theses parts:
1. Cover (B)
2. Air inlet filter (C)
Caution: Prevent
contamination of other
parts of the EVSE. Make
sure that contamination on
the filter does not come off.
5. Install the new air inlet filter. Make sure that the air flow direction that is
indicated on the air inlet filter corresponds with the air flow.
6. Install these parts:
1. Clean air inlet filter
2. Cover
7. Tighten the nuts.
8. Do the steps 3 to 7 again for the other air inlet filters.
9. Close the doors. Refer to section 8.2 .
7.5 Replace the air outlet filter
Preliminary requirements
• Owner • Air outlet filters. Refer to
section 10.22 .
• Spanner
Procedure
1. De-energize the EVSE. Refer to section
6.6 .
2. Open the right door. Refer to section
8.1 .
3. Loosen the nuts (A).
Use the spanner.
4. Pull the cover (B) to the front.
C
B
A
A
C
A
A
B
Maintenance and cleaning
9AKK108466A3703-EN | 001 67