ABB ACSM1 Series, Руководство по прошивке

Страница: 101 / 334

Parameters and firmware blocks
101
22.03 MOTOR GEAR MUL FW block: SPEED FEEDBACK (see above)
Defines the motor gear numerator for the motor encoder gear function.
where input speed is encoder 1/2 speed ( 1.08 ENCODER 1 SPEED / 1.10 ENCODER 2 SPEED ) or
speed estimate ( 1.14 SPEED ESTIMATED ).
See section Motor encoder gear function on page 45 .
-2
31
… 2
31
-1 Numerator for motor encoder gear. Note: A setting of 0 is changed
internally to 1.
22.04 MOTOR GEAR DIV FW block: SPEED FEEDBACK (see above)
Defines the motor gear denominator for the motor encoder gear function. See parameter 22.03
MOTOR GEAR MUL .
1 … 2
31
-1 Denominator for motor encoder gear.
22.05 ZERO SPEED LIMIT FW block: SPEED FEEDBACK (see above)
Defines the zero speed limit. The motor is stopped along a speed ramp until the defined zero speed
limit is reached. After the limit, the motor coasts to stop.
Note: Too low a setting may result in the drive not stopping at all.
0…30000 rpm Zero speed limit.
22.06 ZERO SPEED DELAY FW block: SPEED FEEDBACK (see above)
Defines the delay for the zero speed delay function. The function is useful in applications where
a smooth and quick restarting is essential. During the delay the drive knows accurately the rotor
position.
No Zero Speed Delay
The drive receives a stop command and decelerates along a ramp. When the motor actual speed falls
below an internal limit (called Zero Speed), the speed controller is switched off. The inverter
modulation is stopped and the motor coasts to standstill.
With Zero Speed Delay
The drive receives a stop command and decelerates along a ramp. When the actual motor speed falls
below an internal limit (called Zero Speed), the zero speed delay function activates. During the delay
the function keeps the speed controller live: the inverter modulates, motor is magnetised and the drive
is ready for a quick restart. Zero speed delay can be used e.g. with the jogging function.
0…30000 ms Zero speed delay.
22.03 MOTOR GEAR MUL
22.04 MOTOR GEAR DIV
------------------------------------------------------------------------
Actual speed
Input speed
---------------------------------- =
Speed controller
switched off: Motor
coasts to stop.
Speed controller remains live.
Motor is decelerated to true 0
speed.
No Zero Speed Delay With Zero Speed Delay
Speed
Speed
22.05 ZERO SPEED LIMIT
22.06 ZERO SPEED DELAY
Time Time