ABB ACS880 ESP, Руководство по прошивке

Страница: 351 / 494

Parameters 351
97.15 Motor model
temperature
adaptation Selects whether the temperature-dependent parameters
(such as stator or rotor resistance) of the motor model
adapt to actual (measured or estimated) temperature or
not.
See parameter group
35 Motor thermal protection for
selection of temperature measurement sources.
Disabled
Disabled Temperature adaptation of motor model disabled. 0
Estimated
temperature Estimated temperature ( 35.01 Motor estimated
temperature ) used for adaptation of motor model.
1
Measured
temperature 1 Measured temperature 1 ( 35.02 Measured temperature 1 )
used for adaptation of motor model.
2
Measured
temperature 2 Measured temperature 2 ( 35.03 Measured temperature 2 )
used for adaptation of motor model.
3
97.32 Motor torque
unfiltered Unfiltered motor torque in percent of the nominal motor
torque
-1600.0 … 1600.0% Unfiltered motor torque.
97.33 Speed estimate filter
time Defines a filtering time for estimated speed. See the
diagram on page
480 .
5.00 ms
0.00 … 100.00 ms Filtering time for estimated speed. 1 = 1 ms
98
98 User motor
parameters
Motor values supplied by the user that are used in the
motor model.
These parameters are useful for non-standard motors, or
to just get more accurate motor control of the motor on
site. A better motor model always improves the shaft
performance.
98.01 User motor model
mode Activates the motor model parameters 98.02 … 98.14 and
the rotor angle offset parameter 98.15 .
Notes:
• Parameter value is automatically set to zero when ID
run is selected by parameter 99.13 ID run requested .
The values of parameters 98.02 … 98.15 are then
updated according to the motor characteristics identified
during the ID run.
• Measurements made directly from the motor terminals
during the ID run are likely to produce slightly different
values than those on a datasheet from a motor
manufacturer.
• This parameter cannot be changed while the drive is
running.
Not selected
Not selected Parameters 98.02 … 98.15 inactive. 0
Motor parameters The values of parameters 98.02 … 98.14 are used as the
motor model.
1
Position offset The value of parameter 98.15 is used as the rotor angle
offset. Parameters 98.02 … 98.14 are inactive.
2
Motor parameters &
position offset The values of parameters 98.02 … 98.14 are used as the
motor model, and the value of parameter 98.15 is used as
the rotor angle offset.
3
No. Name/Value Description Def/
FbEq16