ABB ACS880-1604, Руководство по оборудованию

Страница: 77 / 222

Electrical installation 77
6. Strip the cable ends and conductors. When connecting to the drive I/O, also remove
the shield along with the outer sheathing, and use electrical tape or shrink tubing to
contain the strands. Elsewhere, twist the outer shield strands into a bundle, crimp a
lug onto it and connect it to the nearest chassis grounding point.
7. Connect the conductors to appropriate terminals.
8. Fasten the shrouds (if any).
9. Close the doors.

Fiber optic connectors of the DC/DC converter module
The figure shows the fiber optic connections of the DC/DC converter R8i module.
2
3 4
1
Keep as short as possible
*If no dedicated “shield” connector
is provided, ground the inner cable
shields to the chassis.
SHIELD*
Where grounding clamps are not
available, twist the shield strands
into a bundle, crimp a lug terminal
onto it and fasten the lug to the
chassis. Secure the cable into place
with eg. cable ties. At the other end of the cable, leave
the shield unconnected, or connect
it to ground via a capacitor with a
value of a few nanofarads.
BSFC
V50
V60
BFPS
V30
V40
BCU
V10
V20
BSFC Charging controller connection (see section DC
bus connection and capacitor charging on page
24 )
Must be connected by the installer.
BFPS Fan control connection (to fan control box)
Connected at the factory.
BCU Control unit connection
Must be connected by the installer.