ABB ACS880-11, Руководство по оборудованию

Страница: 55 / 232

￭
North America
Installations must be compliant with NFPA 70 (NEC)
1)
and/or Canadian Electrical Code
(CE) along with state and local codes for your location and application.
1)
National Fire Protection Association 70 (National Electric Code).
￭
Other regions
The disconnecting device must conform to the applicable local safety regulations.
Examining the compatibility of the motor and drive
Use asynchronous AC induction motors, permanent magnet synchronous motors, AC
induction servomotors or ABB synchronous reluctance motors (SynRM motors) with
the drive.
Select the motor size and drive type from the rating table on basis of the AC line voltage
and motor load. You can find the rating table in the appropriate hardware manual. You
can also use the DriveSize PC tool.
Make sure that the motor can be used with an AC drive. See Requirements
table (page 56) . For basics of protecting the motor insulation and bearings in drive
systems, see Protecting the motor insulation and bearings (page 55) .
Note:
• Consult the motor manufacturer before using a motor whose nominal voltage differs
from the AC line voltage connected to the drive input.
• The voltage peaks at the motor terminals are relative to the supply voltage of the
drive, not the drive output voltage.
￭
Protecting the motor insulation and bearings
The drive employs modern IGBT inverter technology. Regardless of frequency, the drive
output comprises pulses of approximately the drive DC bus voltage with a very short
rise time. The pulse voltage can almost double at the motor terminals, depending on
the attenuation and reflection properties of the motor cable and the terminals. This can
cause additional stress on the motor and motor cable insulation.
Modern variable speed drives with their fast rising voltage pulses and high switching
frequencies can generate current pulses that flow through the motor bearings. This can
gradually erode the bearing races and rolling elements.
d u /d t filters protect motor insulation system and reduce bearing currents. Common mode
filters mainly reduce bearing currents. Insulated N-end (non-drive end) bearings protect
the motor bearings.
Guidelines for planning the electrical installation 55