ABB ACS880-07LC, Руководство по оборудованию

Страница: 101 / 222

Installing option modules
￭ Mechanical installation of I/O extension, fieldbus adapter and pulse
encoder interface modules
See hardware description for the available slots for each module. Install the option modules
as follows:
WARNING!
Obey the instructions in chapter Safety instructions . If you ignore them, injury or
death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section Electrical safety precautions (page 16) before
you start the work.
2. Open the door of the auxiliary control cubicle (ACU).
3. Remove the shrouding at the top of the cubicle.
4. Locate the inverter control unit (A41).
5. Insert the module carefully into its position on the control unit.
6. Fasten the mounting screw.
Note: The screw secures and grounds the module. It is essential for fulfilling the EMC
requirements and for proper operation of the module.
￭ Installation of an FSO-xx safety functions module onto BCU
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them,
injury or death, or damage to the equipment can occur.
This procedure describes the installation of an FSO-xx safety functions module onto the
BCU control unit. (The FSO-xx can alternatively be installed beside the control unit, which
is the standard with factory-installed FSO-xx modules. For instructions, see the FSO-xx
manual.)
1. Stop the drive and do the steps in section Electrical safety precautions (page 16) before
you start the work.
2. The FSO-xx comes with alternative bottom plates for mounting on different units. For
mounting on the BCU, the mounting points should be located at the long edges of the
module as shown. Replace the bottom plate of the FSO-xx if necessary.
Electrical installation 101
11