ABB ACS880-04F, Руководство по оборудованию, Страница: 165 / 172

Resistor braking 165
17
Resistor braking
Contents of this chapter
This chapter describes how to select, protect and wire brake choppers and resistors. The
chapter also contains the technical data.
Operation principle and hardware description
The dive can be equipped with optional built-in brake chopper (+D150). Brake resistors
are available as add-on kits.
The brake chopper handles the energy generated by a decelerating motor. The chopper
connects the brake resistor to the intermediate DC circuit whenever the voltage in the
circuit exceeds the limit defined by the control program. Energy consumption by the
resistor losses lowers the voltage until the resistor can be disconnected.
Planning the braking system

Selecting the default brake circuit components
1. Calculate the maximum power generated by the motor during braking ( P
max
).
2. Select a suitable drive, brake chopper and brake resistor combination for the
application from the rating table on page 119 . The braking power of the chopper must
be greater or equal than the maximum power generated by the motor during the
braking.
3. Check the resistor selection. The energy generated by the motor during a 400-second
period must not exceed the resistor heat dissipation capacity E
R
.
Note : If the E
R
value is not sufficient, it is possible to use a four-resistor assembly in