ABB ACS880-04F-504A-3, Руководство по оборудованию

Страница: 99 / 202

A PC (with, for example, the Drive composer PC tool) can be connected as follows:
1. Connect a ACS-AP-… or ACH-AP-… control panel to the unit either
•
by inserting the control panel into the panel holder or platform, or
• by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
?
Start
Stop Loc/Rem
?
Start Stop
Loc/Rem
USB connected
3a
4
3b
2
2
Installing option modules
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Pay attention to the free space required by the cabling or terminals coming to the
option modules.
1. Repeat the steps described in Electrical safety precautions (page 16) .
2. Pull out the lock (a).
Note: The location of the lock depends on the module type.
3. Install the module to a free option module slot on the control unit.
4. Push in the lock (a).
5. Tighten the grounding screw (b) to a torque of 0.8 N·m (7 lbf·in).
Note: The screw tightens the connections and grounds the module. It is essential
for fulfilling the EMC requirements and for proper operation of the module.
WARNING!
Do not use excessive force, or leave the screw too loose. Over-tightening
can damage the screw or module. A loose screw can cause an operation
failure.
Electrical installation 99
11