ABB ACS880-04F-504A-3, Руководство по оборудованию

Страница: 22 / 202

The instructions and technical data which concern only certain optional selections are
marked with option codes, for eE208. The options included in the drive can
be identified from the option codes visible on the type designation label. The option
selections are listed in section
Type designation key (page 33) .
Quick installation, commissioning and operating flowchart
See Task
Guidelines for planning the mechanical installa-
tion (page 37) Plan the mechanical and electrical installation and
acquire the accessories needed (cables, fuses, etc.).
Check the ambient conditions, ratings, required
cooling air flow, input power connection, compatib-
ility of the motor, motor connection, and other
technical data.
Guidelines for planning the electrical installa-
tion (page 57)
Technical data (page 131)
Resistor braking (page 191)
Option manual (if optional equipment is included)
Moving and unpacking the unit (page 45) Unpack and check the units.
Examining the delivery (page 49) Check that all necessary optional modules and
equipment are present and correct.
If the drive has not been powered (either in storage
or unused) for a year or more, the converter DC link
capacitors need to be reformed. (
Reforming the
capacitors (page 125) )
Only intact units can be started up.
Examining the installation site (page 45) Check the installation site. Fasten the base of the
cabinet to the floor.
Ambient conditions (page 150)
Routing the cables (page 71) Route the cables.
Measuring the insulation (page 84) Check the insulation of the supply cable, the motor
and the motor cable and the resistor cable (if
present).
Mechanical installation (page 45) Installing the drive module
Connecting the power cables (page 86)
• Install the drive module into the cabinet.
• Install the additional components into the cabin-
et: for example, main disconnector, main contact-
or, main AC, fuses, etc.
• Connect the motor cables to the drive module
terminals.
• Connect the brake resistor and DC connection
cables (if any) to the drive module terminals.
• If the main disconnector is installed into the
cabinet, connect it to the drive module terminals
and the input power cabling to the disconnector.
• Connect the cables from the drive module to the
external control unit and install the control unit
into the cabinet.
Connecting the external control unit to the drive
module (page 91)
Attaching the external control unit (page 53)
Manuals for any optional equipment
Connecting the control cables to the terminals of
the external control unit (page 94) Connect the external control cables to the drive
control unit.
Installation checklist (page 111) Check the installation.
22 Introduction to the manual