ABB ACS860, Руководство по прошивке, Страница: 81 / 438

Application macros 81

Default control connections for the Factory macro
Fault
XPOW External power input
1 +24VI
24 V DC, 2 A
2 GND
XAI Reference voltage and analog inputs
1 +VREF 10 V DC, R
L
1…10 kohm
2 -VREF -10 V DC, R
L
1…10 kohm
3 AGND Ground
4 AI1+ Speed reference
0(2)…10 V, R
in
> 200 kohm
5 AI1-
6 AI2+ By default not in use.
0(4)…20 mA,
R
in
= 100 ohm
7 AI2-
XAO Analog outputs
1 AO1 Motor speed rpm
0…20 mA, R
L
< 500 ohm
2 AGND
3 AO2 Motor current
0…20 mA, R
L
< 500 ohm
4 AGND
XD2D Drive-to-drive link
1 B
Master/follower, drive-to-drive or embedded fieldbus
interface connection
2 A
3 BGND
XRO1, XRO2, XRO3 Relay outputs
1 NC Ready run
250 V AC / 30 V DC
2 A
2 COM
3 NO
1 NC Running
250 V AC / 30 V DC
2 A
2 COM
3 NO
1 NC Fault (-1)
250 V AC / 30 V DC
2 A
2 COM
3 NO
XD24 Digital interlock
1 DIIL Run enable
2 +24VD +24 V DC 200 mA
3 DICOM Digital input ground
4 +24VD +24 V DC 200 mA
5 DIOGND Digital input/output ground
XDIO Digital input/outputs
1 DIO1 Output : Ready run
2 DIO2
Input : Used for R8i main fan fault
monitoring(Connected to the auxiliary contact of fan
control circuit controlled by end user).
XDI Digital inputs
1 DI1 Stop (0) / Start (1)
2 DI2 Forward (0) / Reverse (1)
3 DI3 Reset
4 DI4 Acc/Dec time set 1 (0) / set 2 (1)
5 DI5 Constant speed 1 (1 = On)
6 DI6 By default, not in use.
XDIL
Drive interlocked circuits must be closed for the drive to start. See
Hardware manual of drive.
X13 Control panel connection
X205 Memory unit connection