ABB ACS800-37-0060-3, Руководство по оборудованию

Страница: 141 / 228

Technical data
141
“C-tick” marking
“C-tick” marking is required in Australia and New Zealand. A “C-tick” mark is attached to each drive in
order to verify compliance with the relevant standard (IEC 61800-3 (2004) – Adjustable speed electrical
power drive systems. Part 3: EMC product standard including specific test methods), mandated by the
Trans-Tasman Electromagnetic Compatibility Scheme.
Definitions
EMC stands for E lectro m agnetic C ompatibility. It is the ability of electrical/electronic equipment to
operate without problems within an electromagnetic environment. Likewise, the equipment must not
disturb or interfere with any other product or system within its locality.
The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced by the Australian
Communication Authority (ACA) and the Radio Spectrum Management Group (RSM) of the New
Zealand Ministry of Economic Development (NZMED) in November 2001. The aim of the scheme is to
protect the radiofrequency spectrum by introducing technical limits for emission from electrical/
electronic products.
First environment includes establishments connected to a low-voltage network which supplies buildings
used for domestic purposes.
Second environment includes establishments connected to a network not supplying domestic premises.
Drive of category C2: drive of rated voltage less than 1000 V and intended to be installed and
commissioned only by a professional when used in the first environment. Note: A professional is a
person or organisation having necessary skills in installing and/or commissioning power drive systems,
including their EMC aspects.
Drive of category C3: drive of rated voltage less than 1000 V and intended for use in the second
environment and not intended for use in the first environment.
Drive of category C4: drive of rated voltage equal to or above 1000 V, or rated current equal to or above
400 A, or intended for use in complex systems in the second environment.
Compliance with the EN 61800-3 (2004)
First environment (drive of category C2)
The drive complies with the standard with the following provisions:
1. The drive is equipped with EMC E202.
2. The motor and control cables are selected as specified in the Hardware Manual .
3. The drive is installed according to the instructions given in the Hardware Manual .
4. Maximum cable length is 100 metres (328 ft).
WARNING! In a domestic environment, this product may cause radio interference, in which case
supplementary mitigation measures may be required.
Note: It is not allowed to install a drive equipped with EMC E202 on IT (unearthed) systems. The
supply network becomes connected to earth potential through the EMC filter capacitors which may
cause danger or damage the unit.