ABB ACS800-37-0060-3, Руководство по оборудованию

Страница: 136 / 228

Technical data
136
Maximum recommended
motor cable length 100 m (328 ft). Motor cables up to 500 m (1640 ft) long are allowed but EMC filtering
within the specified limits will not be realised.
Efficiency
> 97% (at rated current and nominal supply voltage)
Cooling
Method Internal fans, flow direction from bottom to top
Filter material Inlet (door) Outlet (roof)
IP22/IP42 units Luftfilter airTex G150 –
IP54 units Luftfilter airComp 300-50 Luftfilter airTex G150
Free space around the unit See chapter Mechanical installation .
Cooling air flow See IEC ratings.
Degrees of protection
IP21; IP22; IP42; IP54, IP54R (with air outlet duct)
Ambient conditions
Environmental limits for the drive are given below. The drive is to be used in a heated,
indoor, controlled environment.
Operation
installed for stationary use
Storage
in the protective package
Transportation
in the protective package
Installation site altitude 0 to 4000 m (13123 ft) above
sea level [above 1000 m
(3281 ft), see section
Derating ]
- -
Air temperature -15 to +50 °C (5 to 122 °F).
See section Derating .
-40 to +70 °C (-40 to +158°F) -40 to +70 °C (-40 to +158°F)
Relative humidity 5 to 95% Max. 95% Max. 95%
No condensation allowed. Maximum allowed relative humidity is 60% in the presence of
corrosive gases.
Contamination levels
(IEC 60721-3-3, IEC 60721-3-
2, IEC 60721-3-1)
No conductive dust allowed.
Boards without coating:
Chemical gases: Class 3C1
Solid particles: Class 3S2
Boards with coating:
Chemical gases: Class 3C2
Solid particles: Class 3S2
Boards without coating:
Chemical gases: Class 1C2
Solid particles: Class 1S3
Boards with coating:
Chemical gases: Class 1C2
Solid particles: Class 1S3
Boards without coating:
Chemical gases: Class 2C2
Solid particles: Class 2S2
Boards with coating:
Chemical gases: Class 2C2
Solid particles: Class 2S2
Atmospheric pressure 70 to 106 kPa
0.7 to 1.05 atmospheres 70 to 106 kPa
0.7 to 1.05 atmospheres 60 to 106 kPa
0.6 to 1.05 atmospheres
Vibration (IEC 60068-2) Max. 1 mm (0.04 in.)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz) sinusoidal
Max. 1 mm (0.04 in.)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz) sinusoidal
Max. 3.5 mm (0.14 in.)
(2 to 9 Hz),
max. 15 m/s
2
(49 ft/s
2
)
(9 to 200 Hz) sinusoidal