ABB ACS480, Руководство по оборудованию, Страница: 36 / 180

• Make sure that the cooling air exhaust at the top of the drive is not below the cooling
air inlet at the bottom of the drive.
• Make sure that the hot exhaust air from a drive does not flow into the cooling inlet of
other drives or equipment.
• Drives equipped with the optional UL type 1 kits: If you install the drives side-by-side,
make sure that their air outlets do not face each other.
Examining the installation site
Examine the installation site:
• The installation site is sufficiently ventilated or cooled to remove heat from the drive.
See the technical data.
• The ambient conditions of the drive meet the specifications. See the technical data.
• The wall behind the unit and the material above and below the unit is of non-flammable
material.
• The installation surface is as close to vertical as possible and strong enough to support
the drive.
• There is enough free space around the drive to enable cooling, maintenance, and
operation. See the free space specifications for the drive.
• Make sure that there are no sources of strong magnetic fields such as high-current
single-core conductors or contactor coils near the drive. A strong magnetic field can
cause interference or inaccuracy in the operation of the drive.
Required tools
To install the drive mechanically, you need the following tools:
• a drill and suitable drill bits
• a screwdriver or wrench with a set of suitable bits (PH0–3, PZ0–3, T15–40, S4–7) (For
motor cable terminals, the recommended shaft length is 150 mm (5.9 in))
• a tape measure and spirit level
• personal protective equipment.
Unpacking the delivery
Make sure that all of the items are present and that there are no signs of damage.
Standard drive package contents:
• Drive
• Assistant control panel (not installed)
• I/O & EIA-485 module RIIO-01 (not installed)
• Mounting template (for R3 and larger drives)
• Installation accessories (cable clamps, etc.)
• Options, if ordered with a plus code. Note that if a fieldbus adapter is ordered, it replaces
the I/O & EIA-485 module RIIO-01 of the standard delivery.
• Multilingual warning sticker sheet (residual voltage warning)
• Safety instructions
• Quick installation and start-up guide
• Hardware and firmware manuals, if ordered with a plus code.
36 Mechanical installation
4