ABB ACS180, Руководство по оборудованию, Страница: 38 / 168

• Make sure that the hot cooling air from a drive does not go into the cooling
air inlet of other equipment.
• Install the drive inside a cabinet or enclosure. The drive has an IP20 (UL Open
Type) ingress protection classification for cabinet installation.
Examining the installation site
Examine the installation site. Make sure that:
• The installation site is sufficiently ventilated or cooled to remove heat from
the drive. See the technical data.
• The ambient conditions of the drive meet the specifications. See the technical
data.
• The material behind, above and below the drive is non-flammable.
• The installation surface is as close to vertical as possible and strong enough
to support the drive.
• There is sufficient free space around the drive for cooling, maintenance, and
operation. See the free space specifications for the drive.
• Make sure that there are no sources of strong magnetic fields such as
high-current single-core conductors or contactor coils near the drive. A strong
magnetic field can cause interference or inaccuracy in the operation of the
drive.
Required tools
To install the drive mechanically, you need these tools:
• a drill and suitable drill bits
• a screwdriver or wrench with a set of suitable bits
• a tape measure and spirit level
• personal protective equipment.
Unpacking the delivery
The figure shows the drive package with its contents. Make sure that all of the
items are present and that there are no signs of damage.
38 Mechanical installation
4