ABB ACS180, Руководство по оборудованию, Страница: 119 / 168

• Radiated emissions are according to C2 with single phase ACS180-04S...-1
drives. For ACS180-04S...-4 drives, use a metal enclosure to fulfill radiated
emissions C2/C1 limits with an external EMC filter.
• External EMC filter must be used together with ACS180-04S-... drives.
• For ACS180-04N... drives, the maximum motor cable lengths are according to
the motor cable length table. The EMC category for these drives is C4.
• For ACS180-04S-...-2 drives, the EMC category is C4. In order to achieve higher
EMC category, must use external EMC filters.
Control connection data
0 … 10 V DC (10% overrange, 11 V DC max.) Voltage signal, single-
ended Analog inputs (AI1,
AI2)
Rin = 38 kohm
0 … 20 mA (10% overrange, 22 mA max.)
Current signal, single-
ended
Rin = 205 ohm
≤ 1.0%, of full scale
Inaccuracy
10 V DC ±1%, max. load current 10 mA Potentiometer refer-
ence value
0 … 20 mA (10% overrange, 22 mA max.) into
maximum 500 ohm load Current output mode Analog output (AO)
0 … 10 V DC (10% overrange, 11 V DC max.)
into 200 kohm minimum load (resistive) Voltage output mode
≤ 1.5%, of full scale Inaccuracy
+24 V DC ±10%, max. 100 mA As output Auxiliary voltage out-
put (+24V)
12 … 24 V DC (int. or ext. supply) max. 30 V
DC. Voltage Digital inputs
(DI1…DI4)
PNP and NPN Type
Rin = 2 kohm Input impedance
As outputs Digital output(DO)
Transistor output PNP Type
30 V DC Max. switching
voltage
60 mA / 30 V DC, short-circuit protected Max. switching cur-
rent
1 form C (NO + NC) Type Relay output (RA, RB,
RC))
250 V AC / 30 V DC Max. switching
voltage
2 A Max. switching cur-
rent
10 Hz…16 kHz Frequency input
DI3 and DI4 can be used as digital or frequency inputs. (FI)
Technical data 119