ABB ACS 600 MultiDrive, Информация о безопасности и продукции

Страница: 65 / 70

ACS 600 MultiDrive – Technical Data
ACS 600 MultiDrive A-41
The ACS 600 MultiDrive frequency converters comply with AS/NZS 2064 for class A
equipment (suitable for use in all establishments other than domestic and those directly
connected to a low-voltage network which supplies buildings used for domestic
purposes). The compliance is valid with the following provisions:
1. The ACS 600 MultiDrive is equipped with EMC filtering (refer to Table A-1).
2. The ACS 600 MultiDrive is installed according to the instructions given in the
Hardware Manual (EN code 63700118).
3. The motor and control cables used are selected as specified in the Hardware
Manual (EN code 63700118).
4. Maximum cable length is 100 metres.
Note: The ACS 600 MultiDrive must not be equipped with EMC filtering (refer to Table
A-1) when installed to IT networks. The mains becomes connected to earth potential
through the EMC filter capacitors. In IT networks this may cause danger or damage the
unit.
Equipment Warranty
and Liability General: ABB warrants the Equipment supplied by ABB against defects in material and
workmanship for a period of twelve (12) months after installation or twenty-four (24)
months from date of shipment from factory, whichever first occurs.
Should any failure to conform with the applicable warranties appear during the
specified periods under normal and proper use and provided the Equipment has been
properly stored, installed, operated and maintained, and if given prompt notice by
Purchaser, ABB shall correct such nonconformity, at its option; by (1) repair or
replacement of the nonconforming equipment or parts thereof. Repairs or
replacements pursuant to warranty shall not renew or extend the applicable original
equipment warranty period, provided however, that any such repairs or replacement of
equipment or parts thereof shall be warranted for the time remaining of the original
warranty period or 30 days, whichever is longer.
ABB shall not be responsible for providing working access to the defect, including
disassembly and reassembly of equipment or for providing transportation to and from
repair or factory facility, all of which shall be at Purchaser’s risk and expense.
These warranties shall not apply to any Equipment or parts thereof which (1) have
been improperly repaired or altered; (2) have been subjected to misuse, negligence or
accident; (3) have been used in a manner contrary to ABB’s instructions; (4) are
comprised of materials provided or designed stipulated by Purchaser; or (5) are used
equipment.
The foregoing warranties are exclusive and in lieu of all other warranties of quality and
performance, written, oral or implied, and all other warranties including any implied
warranties of merchantability or fitness for a particular purpose are hereby disclaimed
by ABB and all equipment manufacturers
.
Correction of nonconformities in the manner and for the period of time provided above
shall be the Purchaser’s exclusive remedy and shall constitute fulfilment of all liabilities
of ABB and any Equipment manufacturer (including any liability for direct, indirect,
special, incidental or consequential damages) whether in warranty, contract,
negligence, tort, strict liability, or otherwise with respect to any nonconformance of or
defect or deficiency in the equipment supplied or services furnished hereunder.