ABB ACQ580, Руководство по прошивке

Страница: 377 / 422

Fieldbus control through the embedded fieldbus interface (EFB) 373

Control Word for the DCU Profile
The embedded fieldbus interface writes the fieldbus Control Word as is to the drive
Control Word bits 0 to 15. Bits 16 to 32 of the drive Control Word are not in use.
8 Reserved
9 Reserved
10 REMOTE_
CMD 1 Fieldbus control d.
0 Control Word <> 0 or Reference <> 0: Retain last Control
Word and Reference.
Control Word = 0 and Reference = 0: Fieldbus control d.
Reference and deceleration/acceleration ramp are
locked.
11 EXT_CTRL_
LOC 1 Select External Control Location EXT2. Effective if the
control location is parameterized to be selected from the
fieldbus.
0 Select External Control Location EXT1. Effective if the
control location is parameterized to be selected from the
fieldbus.
12 USER_0 Writable control bits that can be combined with drive logic
for application-specific functionality.
13 USER_1
14 USER_2
15 USER_3
Bit Name Value State/Description
0 STOP 1 Stop according to the Stop Mode parameter or the stop
mode request bits (bits 7…9).
0 (no op)
1 START 1 Start the drive.
0 (no op)
2 REVERSE 1 Reverse direction of motor rotation. See in the table
below how this bit and sign of the reference effect the
direction of the motor direction.
0 (no op)
3 Reserved
4 RESET 0=>1 Fault reset if an active fault exists.
0 (no op)
Bit Name Value STATE/Description
Sign of the reference
Positive (+) Negative (-)
Bit REVERSE = 0 Forward Reverse
Bit REVERSE = 1 Reverse Forward