ABB AC-AP Series, Руководство пользователя

Страница: 50 / 74

50 Functions in the Options menu
Setting the reference
You can change the reference when the drive is in the local control mode. You can
also change the reference in remote control mode if the drive configuration permits it.
Changes take effect when saved with a key press.
1. Press
to switch to the local control mode, if the text in the top left
corner of the display reads Remote .
2. In the Options menu, select Reference .
3. Change the reference by using the following keys:
• Use or to select a digit to edit.
• Use and to change the value of the selected digit.
4. Press
(
Save
)
to save the reference value, or ( Cancel ) to discard the
changes. The control panel returns to the Home view.
Tip: To adjust the reference from the Home view, press
or and the reference changes immediately. The
reference value is highlighted when you are changing it. If
you hold down the arrow key, the rate at which the value
changes accelerates.
Editing the contents of the Home view
1. In the Options menu, select Edit Home view . This opens the Home view in the
editing mode.
2. In the editing mode, you can add, edit and delete the displayed parameters.
After editing the contents, press ( Done ) to confirm the changes and to exit
the editing mode and return to the Home view.
3. In the editing mode, use and to move between the different pages of the
Home view.
• To add a new page, navigate to the page that reads Press Add to make a new
screen.
• To edit, add or delete parameters on an existing page, navigate to that page.
Loc/Rem
60.0
1200.0 rpm
Two-signal page in editing mode Empty page in editing mode
Softkey labels
and a blinking
cursor indicate
that the
control panel is