SE
Om du upplever ihärdiga eller återkommande symtom som obehag, smärta, bankande, värk, stickningar, domningar,
burning sensation, or stiffness: Do not ignore these warning signs. Stop using the tool, tell your employer and
consult a qualified health professional.
USING THE SAND BLASTING GUN WITH FEED HOSE
Before operating the equipment, put some oil drops in the air inlet opening (A) of the pneumatic tool.
Insert the sand feeding hose (D) inside the box containing the abrasive dust.
Choose the correct nozzle (C) and mount it onto the gun. While directing the sand flow towards a scrap piece,
depress the trigger (B) to start the tool and adjust the compressor flow in order to obtain the desired pattern.
For better results the noozle must be in contact with the object surface, or at least very close (2-3 centimenters).
MAINTENANCE
Disconnect the air supply during maintenance on the tool.
Regularly clean and dry the filter in the system and the pneumatic tool air inlet opening.
Lubricate any quick-disconnect coupling on the system to prevent jamming.
Drain condensation from air filter and from the compressor on a daily basis.
In order to avoid rust formation and to minimize wear, clean and lubricate the tool after each use.
Check the tool regularly on loose bolts/screws or parts.
In case of power loss: have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
In case the tool is equipped with a silencer, make sure that this silencer is working properly, a damaged silencer has
to be replaced.
The tool should be maintained regularly to minimize the noise emission and occurring vibration.
If you intend not to use the tool for a longer period of time, it has to be oiled. Please fill some droplets of resin and
acid free oil into the air inlet and let the tool run free for a couple of seconds.
Maintain the tool at least yearly.
INTENDED USE
The user or the user’s employer shall assess the specific use that can be present as a result of each use.
Never use the tool otherwise than the tool is designed for and as explained in this manual.
Damages as a consequence of not following this manual, or caused by incorrect use or incorrect repairs, will never be
covered by our warranty and we will have no responsibility for it. We reserve the right for technical improvements,
without prior notification.
This tool is designed for spraying abrasive dusts. If used otherwise a risk assessment has to be made by the employer/
user.
POSSIBLE FAULTS
Immediately shut down the equipment in case you hear unusual noises, or if a sudden power drop occurs. Check the
pneumatic tool and the compressed air supply system.
Pneumatic tool
-
lubrication is insufficient
-
worn tool/accessory, not suitable for use or faulted
- tool or feeding hose clogged: carefully check and remove any obstructing clump
Compressed air supply system
-
compressor pressure is insufficient
-
pressure regulator not set on the correct pressure level, suitable to the tool being used.
100
