ab Solares Smart Spa, Руководство по эксплуатации

Страница: 33 / 40

Solares™ Smart Spa Bathing System Operating Manual
CD0036 - 33 - 1121
mechanically setting Rada’s temperature
limit. The current temperature read in the
manifold is located below this button.
Advanced Maintenance – brings you to
Advanced Maintenance Screen.
Reset Top/ Bottom UV Bulb Life – pushing
these buttons will reset the bulb ’ s estimated
remaining life expectancy. This would
typically be used when replacing a UV bulb.
The estimated life expectance of the bulb is
shown below the button.
Timer adjustments – brings you to the timer
adjustment screens.
Calibrate tub/ thermistor – Used to calibrate
thermistors to ensure accuracy.
Package Configuration – Goes to package
screen, which allows you to enable/ disable
options on the tub.
I/O – Allows you to review the status of
sensors, actuators, valves, etc. Used for
troubleshooting and calibration.
Reset Errors – resets any current errors.
(Displayed to the left of the button.)
Advanced Maintenance
Tub Name – Tap on name to change tub’s
name. Used to identify source of disinfection
data after export.
Calibrate Rada – Fills tub and runs shower
wand at calibration temp to realign
temperature profile. Does not need to be run
but can help the tub find temperatures faster
out of the gate. Even without running this, the
tub will map the Rada as the tub is run at
different temperatures.
Error Log – Displays last 30 errors flagged by
the tub with the latest error on top. Hit
“Forward” to go deeper in the list and “Back”
to move back towards the top.
Timer Adjustments
The Timer Adjustment screens are used for
making timing adjustments to the tub to
accommodate for low water flow or simply to
better adjust the tub’s function to your
facilit y’ s needs. You can adjust any of the
times listed below by touching the number
and entering your desired value in the keypad
that pops up on the screen.
“Return to default
settings” will return all times to initial values.
DS Cleaner – How long the tub runs cleaner
into the tub during the cleaning cycle.
Increasing this value will pull more cleaner
into the tub and help ensure cleaner makes
its way through all the jets.
DS Disinfectant - How long the tub runs
disinfectant into the tub during the
disinfection cycle. Increasing this value will
pull more disinfectant into the tub and help
ensure disinfectant makes its way through all
the jets.
DS Rinse – How long the system runs water
through the plumbing to rinse out cleaning
chemicals. Will lengthen both the first and
middle stages of the rinse process.
Drain/ Rapid Fill Valve – Determines how long
the slide valves on the tub will be powered
when opening. This value can be decreased to
prevent the valve from opening all the way if