Solder the front upstop into it’s slot in the
front T bar. Ensure yo remove any excess
solder around the upstop so the pan upstop
plates do not fowl on the upstop.
Locate the The upstop plate and Front wheel
mount/ upstop plate key in the front slot in
the side pan. Solder in place.
Ensure that pan moves freely without fowling.
Solder the Anti deck plates into the rear of
the pans.
If you wish to use wheel stickers rather than
front wheels, you can trim off the top of the
Front wheel mount.
Solder Pin Tube mounts and Pin tube in place.
Scrub the chassis with domestic abrasive pan cleaner and washing up liquid to remove any crud and traces of acid
flux. Dry the chassis.
Fit your favourite ballraces, pin the front wheels in, fit motor, gears axle, leadwire & guide and Go Race!
Leadwires should locate through the lead wire retainers in the front and centre spine mounts.
The chassis will run best when the front T bar is just off the surface of the track. Space you guide accordingly.
You should also polish a small radius on all edges of the chassis (the front & leading edges of the Tee Bar, leading
and outside edges of the pans etc. This will ensure the chassis won’t “Dig In”.
Favourite gear ratio with a good G12 motor is 7/42, 7/41 or 8/42 in 72 pitch (dependant on track type).
AB recommend JK “B” rear tyres, regular hub for lower grip and big hub / treated when the grip is high.
ENJOY YOUR RACING!
It is highly unlikely you will break any part of this great chassis, but it is our policy to hold spare parts in
stock for all our kits. If you require a spare part, please email us at [email protected].
Now it’s time to drop the Cross Bar into the centre slot in front of the rear spine mount. Note;- the cross bar
“floats” in this slot. Do not solder the cross bar in the centre!
Locate and solder the pan cross bar retainers in place.
Take the four pan straps and trial fit through the holes in the crossbar. If the reduced end will not slide through,
carefully with a dremel, remove a little material from narrowed side of the mount legs only to allow you to slide
these through the cross bar slots.
Locate the pans in position, slide the Pan Straps through the cross bar. Orientate the the pan straps so the
reduced side of the pan strap faces forward on the inside bracket and backwards on the outside bracket.
Ensure pan straps float freely through the cross bar.
Twin 0.032” rail option with both rails
soldered solid in rear receptor slot.