Aavik acoustics I-880, Руководство пользователя

Страница: 7 / 12

I-880 / USER GUIDE 7
REMOTE FACTORY RESET
A
VOLUME UP, Press this button to increase the
volume setting.
B
VOLUME DOWN, Press this button to decrease the
volume setting.
C
INPUT +, Press this button, to move to the next
input. From Line 1 to Line 2 etc.
D
INPUT -, Press this button, to move to the previous
input. From Line 2 to Line 1 etc.
E
STANDBY, Press this button to place the amplifier
in standby mode, or to switch the amplifier on from
standby mode.
F
MENU, Use this button to enter the menu, or switch
back to normal operation. Use the INPUT + and INPUT
- buttons to cycle through the menu, and the VOLUME
UP and VOLUME DOWN buttons to change a setting.
See “MENU FUNCTIONS” for details.
G
MUTE Press the button to mute the outputs of the
amplifier. A small light beneath the display will show
“Mute” when mute is enabled.
You can reset all settings back to factory defaults.
This will erase gain settings, the balance setting and
the remote pairing settings. To do this, proceed as
follows:
• Switch on the amplifier using the standby button
2
or the remote control.
• Press and hold the up and down front panel buttons
(
3
and
5
) simultaneously.
The display will show “Restoring default settings ...”
and then “Shutting down”. The amp will switch off, and
you can turn it back on using the front panel button
2
. The remote control will not work until it has been
paired.
A
C
E
F G
B
In order to pair your remote control with the ampli-
fier, press and hold the front panel mute button for
more than one second. When the amplifier is ready
to pair, the display will flash slowly. To pair, press a
button on your remote control facing it toward the
amplifier. The display will show ”Paired”. Press the
front panel mute button again briefly to go back to
normal operation.
Note: In order to save your settings, set the amplifier in
standby mode by pressing the stand by button (
E
/
2
).
You can remove the pairing, so that the amp will
stop responding to the remote again, by pressing
the front panel mute button for more than five
seconds. When the five seconds have passed,
the displays will flash fast. Press a button on the
remote, to complete the procedure. The display will
show ”Unpaired”. Press the front panel mute button
again briefly to go back to normal operation.
REMOTE PAIRING
D