Aastra OpenCom 100 series, Руководство по монтажу и пусконаладке

Страница: 20 / 256

Factory Settings on Delivery
18
OpenCom 150
With the OpenCom 150 all ports (S
0
, U
pn
and a/b ports) are realised by installing a spe-
cific combination of interface cards for this purpose. An overview of available
interface cards can be found in the “Interface cards”chapter in the section
OpenCom 150 (5 Slots) starting on page 50.
• The OpenCom 100 is configured ready for use in Germany.
• Analogue terminals: The dialling mode (IWV or MFV) is automatically detected.
• All corded terminals connected to the base module ring if there are incoming
external calls.
• The password for the “Administrator” user is empty.
• The system PIN, for remote programmable call diversion for example, is set at
“0000”.
Authorisations
The allocation of authorities regulates which functions terminals on OpenCom 100
can use. These authorities are configured for so-called user groups, to which users and
their terminals are then assigned.
Three user groups are preset: “Administrators”, “Standard” and “Guests”. “Adminis-
trators” can access all functions in OpenCom 100 and have unlimited configuration
rights. Users in the “Guests” group can not configure OpenCom 100, may not make
any external calls and can only use a limited range of OpenCom 100 terminal func-
tions. The “Standard” user group is well suited as a starting point for creating user
groups for normal users of the system (e. g. the staff members of a company) because
of its default settings.
Note
When the OpenCom 100 is commissioned, all connected terminals are initially in the
“Administrators” group until a user logs on to the Web console. Subsequently, all ter-
minals are automatically in the “Guests” group. For more details on the configuration
of user groups, refer to the online help in the chapter entitled “User Manager”.
The following functions are delivered preset for user groups: