Aastra BLUESTAR 8000I, Руководство администратора режима PBX

Страница: 34 / 143

Configuration Files
41-001390-00 Rev 02 – 12.2011
2-2
Update URL
In order for the BluStar 8000i to download the software, there has to be the “ update url ” parameter in either the
<mac>.cfg, <model>.cfg, or aastra.cfg file. It is recommended to have this parameter in the <mac>.cfg file.
For example:
update url: FTP://10.30.102.74/<software name>@2011.04.07.1744
Reference:
For more information of each configuration file parameter, see Appendix A “Parameters” on page A-1 .
For a sample of the configuration files, see Appendix B “Sample Configuration Files” on page B-1 .
Configuration File Precedence
The BluStar 8000i can accept the following sources of configuration data:
• The PBX configuration server most recently downloaded/cached from the configuration server files:
aastra.cfg/<model>.cfg/<mac>.cfg
• The BluStar 8000i user configuration URL( “ user config url ” parameter) that specifies where to look for the <user>.cfg
file. The <user>.cfg file contains the user’s settings, including call logs and favorites.
Installing the Configuration Files
The following procedure describes how to install the configuration files.
Note:
The value specified for this parameter is an untarred directory instead of a file name.
Notes:
• The BluStar 8000i settings include intelligent default values (therefore an empty configuration file is always the best).
Administrators should only set a parameter if they MUST control or override that particular setting.
• The internal BluStar 8000i default values can be dynamically adjusted based on network, call, and other conditions
and settings.
• If a BluStar 8000i setting value is specified in the configuration file, then this dynamic behavior is disabled for that set-
ting.
1. If DHCP is disabled, manually enter the configuration server’s IP address. For details on manually setting DHCP, see
Configuring Network Settings Manually on page 3-6 .
2. On the configuration server, you must have the aastra.cfg, <model>.cfg , and <mac>.cfg files.
Notes:
• The <mac> attribute represents the actual MAC address of your BluStar 8000i (i.e., 00085D112233.cfg ).
• The terminal’s < mac > address can be obtained under the about app menu.
3. Place the mandatory “ user config url ” parameter that specifies where to look for the <user>.cfg file in either the
aastra.cfg, <model>.cfg, or the <mac>.cfg file.
Note:
The “ user config URL " parameter supports tftp, ftp, http, https, however only ftp, http and https can be authenticated.
4. Place the “ update url ” parameter in the <mac>.cfg file.
When the BluStar 8000i is booting up, only the aastra.cfg, <model>.cfg , and <mac>.cfg are loaded.
The <user>.cfg is loaded when the user logs in.
Note:
To login, the BluStar 8000i has to be able to load the <user>.cfg file.
5. Restart the BluStar 8000i as described in Logging Off / Restarting on page 1-14 .