For more than 25 years Aaron Loudspeakers has been produc-
ing speakers of the highest quality. Over the years we have
developed many different technologies that have been acknowl-
edged by the Government, the media and by our own industry.
With this rich heritage we set about designing a very special
range of speakers that pioneers new boundaries in loudspeaker
performance and utilizes ground breaking innovative technology.
However we didn’t just rely on technology we were meticulous in
every facet, paying attention to every minute detail like never
done before.
At the heart of our new Hyperboloid speaker range is our
Hyperboloid technology. Technology that took us more than six
years to fully develop due to its complexities and the meticulous
attitude we took to the design process. The word “Hyperboloid”
mathematically describes the three dimensional shape of the
speaker cone. By using this new type of cone we have achieved
several advantages. When first looked at the most obvious
feature is that this type of speaker cone has no dust cap. No
dust cap means, no foreign object present on the cone’s surface
to produce spurious sounds which cause spectral contamina-
tion. The next striking feature is the cone edge treatment, the roll
surround, is half covered by a trim ring which allows for the better
integration of cone to baffle. Conventional speakers have a bump
caused by the roll surround and a groove between the surround
roll and the trim ring causing wind noise as the air rushes across
the bump and groove. Our configuration has a gap of only 2mm,
of course wind noise is still generated, but due to the much
narrower gap the frequency band is shifted well out of the human
hearing range to 170,000 Hertz. The third and most unique
feature is the Hyperboloid cone shape. When the cone is viewed
as a cross section the shape is in fact an exponential mathemati-
cal progression. This means that each increment of the cones
shape is different from the last and as a result no one single
frequency or frequency range is empathized over another.
The HMF-600 is a wide range floor
standing double 6.5 inch three way
speaker. As a result of their extraordi-
nary linearity regards frequency
response, distortion and electrical
characteristics they are a superb two
channel speaker. They are capable of
reproducing even the most demanding
passages of music with aplomb
creating an image which is unmistak-
ably real and accurate. Home Theatre
sounds can also be reproduced with
ease since they are robustly
constructed and have a wide dynamic
range making it possible for them to
reproduce even the most rigorous of
sound effects.
Both the HCC-300 and HCC-600 use our already highly acclaimed “Anti Lobe Configura-
tion” (ALC). This technology eliminates phase cancellation that occurs in standard centre
channels. Phase cancellation is caused when the relative distance changes between two
drive units in the overlapping frequency range. When you move just slightly to one side of a
conventional centre channel speaker a complex series of wave additions and cancellations
are set up causing a general deterioration of sound quality. We have eliminated this
problem with some innovative new technology called “ALC”. “ALC” works
by combining a scientifically calculated spacing pattern between speaker
components with specially selected crossover frequencies. In this way we
make affected wave lengths longer and proportional spacing shorter
eliminating the margin for error. The HCC-300 is small and perfect for those
circumstances where space is critical ont the other hand the HCC-600 is the ultimate full range centre channel.
HMF-600
HCC-300 & HCC-600
THE ULTIMATE IN RELIABILITY, PREFORMANCE AND TECHNOLOGY
