TO OPEN AWNING:
Back to index
Slide one rafter arm up until it snaps into
place. Pull down and out on the sliding
rafter to remove slack from the fabric,
and tighten the black adjustment knob.
Repeat for other side.
Slide the pull strap to the
right end of the roller, and
wrap it around the main arm.
Pull up on the lift handle and raise the
arm assembly to the desired height.
Swing handle in and allow the lock
button to snap into one of the holes.
Repeat for other side.
Lower arm to shortest position. Press the
release lever at the bottom end of main arm,
pull the arm assembly outward to a verti-
cal position and adjust height. Repeat for
other side. Drive stakes through holes of
each patio foot into the ground. Stake kits
are available from your awning retailer.
During rain, lower the end furthest from the door
to allow water to flow off.
Whenever heavy or prolonged rain or wind is
anticipated, or you will leave the awning unat-
tended, it is best to close the awning. Damage as
a result of weather is not covered by warranty.
TO CLOSE AWNING:
Pull stakes from the ground, lower arm to the shortest position,
swing arm toward the vehicle, and snap the patio foot into the
bracket. Repeat for other side and proceed to next step.
Raise the lift handle to
release the lock button.
Lower main arm to the
stop plug. Swing the
handle in to engage the
lock button in a hole.
Repeat for other side.
A:
Loosen black adjustment knob.
B:
Lift slider catch.
C:
Slide
the rafter arm down to the bottom of the main arm. Leave black
adjustment knob loose. Repeat for other side.
Loosen the black adjustment knob behind each main arm.
• Sunchaser Awnings: push travel latch tab toward center of
arm to disengage.
• 8500/9000/ Awnings: Flip travel
lock latches up.
Using the provided pull rod,
reach up and pull the lock-
ing lever forward to release
the awning.
Hook the rod into the loop of the pull
strap, and pull the awning all the way
out.
5
4
1
2
3
6
7
8
1
2
3
