A&D TM-2441, Инструкция по эксплуатации

Страница: 60 / 120

40
7. Preparing the Recorder
7.1. Installing the Batteries (Replacing Batteries)
Install two new batteries with the correct "+" and "-" direction
inside the battery compartment before attaching the recorder.
Replace both batteries at the same time.
Remove batteries from the recorder if it will not be used for a
long period of time. Batteries may leak and cause a malfunction.
Use two alkaline batteries: type LR6 or designated rechargeable
AA Ni-MH batteries.
When installing the battery in the battery compartment, first, push
the spring terminal using the "-" terminal of the battery. Next,
insert the "+" terminal.
If the battery is installed from the "+" terminal, the coating of the
battery may be damaged by the spring terminal.
Do not mix different kinds of batteries or used batteries and new
batteries. It may cause a leak, heating or damage.
Note
When the level 1 of the battery level is displayed, replace with
two new batteries before attaching the recorder.
The recorder cannot perform blood pressure measurement or data
transfer while the level 1 is displayed.
When the battery and built-in battery are flat, nothing is displayed.
Install batteries in accordance with the direction symbol (
).
Caution