A&D BA-125DTE, Инструкция по эксплуатации

Страница: 103 / 172

103
Data output mode
Display settings: MENU key System settings button Communication button
Data output button Data output mode button [Data output mode] screen
1
2 6
3
4 7
5 8
Name Setting value (setting range) Description
1
Data output
mode
Key mode , Auto print mode,
Stream mode, Interval output mode
Selects the output timing for the selected
data.
2
Key mode
setting
Output only when the display is stable ,
Output regardless of whether the
display is stable or unstable,
Output after the display becomes stable
Selects the output condition for the weighing
value.
3 Bandwidth
10 d , 100 d, 1000 d
Selects the auto print bandwidth.
4 Reference
Zero point , Last stable value
Selects the reference for the weighing
value.
5 Polarity
Positive values only , Negative values
only, Both positive and negative values Selects the auto print polarity.
6
Display
refresh rate
5 times/second , 10 times/second
Selects the display and output rate.
This is common to the setting described in
“
13.1. Display settings ”.
7 Interval time
* -
Sets the interval time for outputting the
weighing value.
8 Back button
-
Returns to the previous screen.
Settings in the red box are default values (factory settings). "d" is a unit of readability.
You can change the data output timing for the balance in the [Data output mode] screen.
* Depending on the interval time and baud rate, all data may not be transmitted unless the baud rate is
increased.
For details about the data output mode, refer to “ 19.1. Data output mode ”.