A&D AD-8923-BCD, Инструкция по эксплуатации, Страница: 16 / 28

16
6. BCD OUTPUT CONNECTOR
Outputs the weighing data received from the weighing instrument in BCD format, along with the polarity
(+/-) and the data status (stable/unstable and over (E display)).
Using the STROBE signal, the data can be read easily. BUSY input enables the data to be held or
prevents data refreshing during the reading operation.
Contact inputs are RE-ZERO and ON/OFF. They have same function as the key switches on the front panel.
6.1. Connector Pin No and Specifications
I/O connector of the rear panel
Pin assignments and I/O logic
Output pin assignments Input pin assignments
Pin No. Signal Pin No. Signal
26 1
10
0
Data
7 BUSY
27 2 9 RE-ZERO
Switch
28 4 5 ON/OFF
29 8 3 Input signal GND
39 1
10
1
11 Do not use
40 2 - The pins, which are not specified, have no
connection. (2, 4, 6, 8, 10, 36, 38 pin)
41 4
42 8
12 1
10
2
Output logic
13 2
Output logic (Factory settings)
14 4 Data ON
15 8 Polarity Positive or zero ON
16 1
10
3
Stability Stabilization indicator ON ON
17 2 Over , ON
18 4 Strobe Changing data
ON*
19 8 * When changing OFF

ON, replaces the data.
20 1
10
4
- All output, open collector; withstand voltage 30 V;
21 2 no pull-up resistor; low-level output current 10 mA
22 4
23 8
46 1
10
5
47 2
48 4
49 8
24 1
10
6
25 2
30 4
31 8
32 1
10
7
33 2
34 4 Input logic
35 8 BUSY Data will be held during ON
(when connected to input signal GND). 50 Polarity
Status
45
Stability
Switch
Switch will be performed with ON
(when connected to input signal GND).
44 Over input
43 Strobe
Controlling
signals
- All input, no voltage contact or open collector
(connected to 5 V internally)
1 Output signal GND
Housing Frame ground
Half pitch 50 pin
50 26
1 25
Balance
interior
0 7
Output pins
BCD
signals
Pin 1
BCD signals
(Data from 10 -1 to 10 -8, Polarity,
Stability, OVER, Status, Strobe)
Output signal GND
Use a shielded cable.
Housing (Cable shield)
FG