AccuFit
™
Blood Pressure Cuffs
© 2013 A&D Medical. All rights reserved. Specifications subject to change without
notice. UA-279/280/281-QSC-Eng-102013 REV. b
1. This cuff is intended for use with A&D Medical or
LifeSource® blood pressure monitors.
2. Intended for upper arm use.
3. Intended for use at home by those who are eighteen
(18) years or older, to monitor blood pressure (systolic
and diastolic) and pulse rate.
4. This cuff is metal and latex free.
5. Avoid tightly folding of this cuff or storing the hose
tightly twisted for long periods, as such treatment may
shorten the life of the components.
6. This cuff is not water resistant. Prevent rain, sweat,
water and moisture of any type from soiling this cuff.
1. Sit comfortably with your left arm
resting on a flat surface so that
the center of your upper arm is
at the same height as your heart.
2. Lay left arm on the table, palm up and
wrap the cuff around the upper arm,
about 0.5" (1-2 cm) above the inside of
the elbow, as shown, place the cuff
directly against the skin, as clothing may
cause a faint pulse, and result in a
measurement error.
3. Secure cuff around arm. The cuff
should be snug but not too tight.
4. Make sure cuff is aligned
at heart level.
• Relax for several moments before measurement.
• Do not smoke or ingest caffeine at least 30 minutes prior
to measurement.
• Remove constricting clothing and place cuff on bare arm.
• Unless your physician recommends otherwise, use left
arm to measure pressure.
• Do not talk during measurement.
• Do not cross legs and keep your feet flat on the floor.
1-888-726-9966
www.andmedical.com
Now you are ready. Follow these simple steps:
