Operators and Maintenance Manual
Display
EEM AM4 FE H01
Page
7/19
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: [email protected]
■
www.aatech.pl
Fig. 3. Mounting hole and screw holes measurements (not to scale)
3.4. Power and wiring
The EEM AM4 display is powered from the aircraft power system. Power
specifications: nominal supply voltage 12V, acceptable supply voltage
range 8
÷
30V, current < 340mA.
The EEM MOT 01 display is connected to the system by four in-built
MOLEX Ultra-Fit 3.5 mm 6 pin male connector located at the back of the
instrument. A schematic diagram of the connection is shown in Figure 4
and in Table 1. Connectors A and B should be connected to measurement
module AUX AVS 2 by RS 0 line. Connectors C and D should be connected
to measurement module EMS DAQ R02 by RS 0 line.
The power supply (pins no. 5 and 6) requires 0.5 mm
2
wires.
