Aaeon HSB-800I-A11, Руководство пользователя, Страница: 33 / 75

Chapter 3 – AMI BIOS Setup 21
Half
-S
iz
ed
ISA
S
BC
HSB
-800I
-A11
3.1 System Test and Initialization
The board uses certain routines to test and initialize board hardware. If the routines
encounter an error during the tests, you will either hear a few short beeps or see an
error message on the screen. There are two kinds of errors: fatal and non-fatal. The
system can usually continue the boot up sequence with non-fatal errors, usually with a
message to press <F1> to resume startup.
System configuration verification routines check the current system configuration
against values stored in the CMOS memory. If a system configuration is not found or if
the values do not match, an error message will be displayed. The BIOS setup will need
to be run to set the configuration information in memory.
There are three situations in which you will need to setup system configuration:
⚫
You are starting your system for the first time.
⚫
You have changed the hardware attached to your system.
⚫
The CMOS memory has lost power and the configuration information has been
erased.
The HSB-800I-A11 CMOS memory uses a backup battery for data retention. The
battery must be replaced if it runs out of power.