A10 Thunder series 930, Руководство по установке

Страница: 24 / 44

A10 Thunder Series 930 Installation Guide
Configuring a New ACOS Device Using an Existing Configuration
Document No.: TH-930-001 - 1/26/2015 | page 24
Save the Configuration Changes
Configuration changes made so far must be saved to the system memory to take effect when the system reboots. Otherwise,
a power interruption (for example) could cause the system to be unavailable from the Web interface, in which case the con-
sole configuration would need to be repeated. Saving the configuration changes prevents this inconvenience. To write the
current configuration to system memory:
ACOS(config)# write mem
Building configuration...
[OK]
Configuring a New ACOS Device Using an Existing
Configuration
If you are planning to configure the new ACOS device by loading the configuration from another ACOS device:
1. On the configured ACOS device, use the copy CLI command to save the startup-config to a remote server.
2. On the new ACOS device, copy the configured ACOS device’s startup-config from the remote server onto the new
ACOS device.
3. Reboot the new ACOS device.
4. Modify parameters as needed (such as IP addresses).